Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the flexible gas conduit between the range and the wall.
2. Do not seal the range to the side
cabinets.
3. 24" (61 cm) minimum clearance
between the cooktop and the
bottom of the cabinet when the
bottom of wood or metal cabinet
is protected by not less than ¼"
(0.64 cm) flame retardant
millboard covered with not less
than No. 28 MSG sheet metal,
0.015"(0.4 mm) stainless steel,
0.024"(0.6 mm) aluminum, or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum
clearance when the cabinet is
unprotected.
4. For cutouts below 22 7/8"(58.1
cm), appliance will slightly show
out of the cabinet.
5. Allow at least 19 ¼" (48.9 cm)
clearance for door depth when it
is open.
*IMPORTANT:
more than 30
1
/
16
opening while pushing into it. Raise leveling legs at maximum position, insert the
appliance in the counter and then level.
leveling legs not by the cooktop glass itself.
IMPORTANT:
Cabinet and countertop
width should match the cutout width.
E
E
A. HEIGHT
B. WIDTH
35 5/8" (90.5 cm) -
30" (76,2 cm)
36 5/8" (93cm)
(Models with Sealed Top Burners)
Door Open
(see note 5)
To avoid cooktop glass breakage for cutout width (E dimension) of
" (76.4 cm), make sure the appliance is centered in the counter
C. COOKTOP
D. DEPTH TO
WIDTH
FRONT OF RANGE
31½" (80 cm)
28 5/16" (71,9 cm)
21¾"
(55.25 cm)
Figure 1
B
Make sure the unit is supported by the
23 1/4" (59.05 cm) max.
FRONT
OF
CABINET
E. CUTOUT WIDTH ***
(Countertop and
Cabinet)
21 3/4" (55,2 cm) Min.
30±1/16"
22 1/8" (56,2 cm) Max
(76,2±0,15 cm)
24" (61 cm) Min. with
2
C
D
Side panel
22 7/8" (58.1 cm) min.
(see Note 4)
1 1/8"
(2.86 cm)
F
Ref.
F. CUTOUT
G. HEIGHT
DEPTH
OF COUNTERTOP
36 5/8" (93 cm) Max.
35 5/8" (90.5 cm) Min.
backguard
A
Publicidad
Tabla de contenido
