Electrical Cord; Polarized Plug; How To Use - Black and Decker Brew ’N Go DCM Serie Guía De Inicio Rápida

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
Mug Lid
2.
Travel Mug
3.
On Light
4.
Start Lever
5.
Mug Rest
6.
Water Reservoir
7.
Reservoir Cover
8.
Max Fill Line
9.
Filter Basket
10. Water Spreader
11. Permanent Filter

ELECTRICAL CORD

The cord length of these Coffeemakers was selected to reduce safety hazards that may
occur with a longer cord. If more cord length is needed, an extension cord may be
used. It should be rated not less than 10 amperes, 120 volts, and should have
Underwriters Laboratories listing. A properly rated extension cord may be purchased
from a Black & Decker Household Appliance Company-Owned or Authorized Service
Center. When using a longer cord, be sure that it does not drape over a working area or
dangle where it could be pulled on or tripped over.

POLARIZED PLUG

Brew 'N Go™ Coffeemakers have a polarized plug (one blade is wider than the other).
As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does
not fit fully into the outlet, reverse it. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature by modifying the plug in any way.

How To Use

BEFORE FIRST USE
Black models may have a white film. Wipe with a
soft cloth to restore the shine. Before first use,
wash the Permanent Filter, Filter Basket, Travel
Mug and Lid. Pour one full Mug of cold tap water
only into the Water Reservoir up to the Max Fill
Line (Figure A). Do not put coffee grounds in the
Filter. Brew the plain water through.
Cover
7
6
10
9
3
11
8
1
2
3
4
5
(Model DCM16 Shown)
Figure A

Publicidad

Tabla de contenido
loading

Tabla de contenido