Steren TEMP-310 Manual De Instrucciones página 17

2. CONTROLS
1. LED CH 1: lights when channel 1 programmed events are ongoing.
2. LED CH 2: lights when channel 2 scheduled events are in progress.
3. CLOCK: Along with the DAY, HOURS, MIN buttons allows you to set the timer for each channel.
4. PROG: Displays and configures the event schedule.
5. MANUAL: Select the mode for each channel.
6. ON: Off programmer. The current passage is allowed. The word "ON" (power) shall be
indicated by an arrow on the screen.
7. AUTO: Enabled programmer. The scheduled events are executed. The word "AUTO"
(automatic) shall be indicated by an arrow on the screen.
8. OFF: Programmer and passage of the current disabled. The word "OFF" (automatic) shall be
indicated by an arrow on the screen.
9. RESET: Press this button to clear the timer settings in case of any failure.
10. CH 1 (channel 1): cable inputs from the device that you want to program. (NO: normally open;
NC: Normally closed).
11.- CH 2 (channel 2): cable inputs from the device that you want to program. (NO: normally
open; NC: Normally closed).
12. Power supply
5