Steren TEMP-310 Manual De Instrucciones página 22

-To set the power off time, repeat the same configuration steps.
-If you want to schedule more events repeat above steps. You can schedule up to four events in
channel 1 (CH 1) and three in the 2 channel (CH 2).
-At the end of program, press CLOCK so that the display returns to standby mode.
To run the timer programmed events you must be in the "AUTO" mode (by pressing MANUAL
button).
During the setup, make the necessary adjustments before that within 2 minutes. Otherwise the
timer will return to standby mode and save the incomplete time.
To view scheduled events press PROG in the standby mode. Press CLOCK again for the time
to appear on the display.
10
-Press HOUR and MIN to specify the time at the connected
device which will turn on.
c
-Press PROG to set the time that the connected device will
turn off. (the message "OFF" will appear in the lower left
corner).
6. EVENT SCHEDULE