WARNINGS
This appliance cannot be used
by people (included children)
with impaired physical, sen
sory or mental abilities or with
lack of experience and know-
ledge, unless they are super-
vised or unless they are given
instructions about the use of
the appliance by a person re
sponsible of their safety.
The room must be adequate-
ly ventilated if the hood and
other appliances powered by
energy other than electrici-
ty are used at the same time.
This prevents the hood from
sucking in any combustion fu-
mes.
It is forbidden to cook food
over open flames, as sucked
flames are a risk of damage for
the appliance.
WARNING: This appliance and
its accessible parts are likely
to become very hot if used in
combination with cooking de-
vices.
In case of installation with gas
hobs the cooker surface and
the inferior part of the cooker
hood must be at a minimun di
stance of 65 cm.
* To evacuate the air outlet, ple-
ase comply with the pertaining
rules given by competent au-
thorities.
* When performing the elec-
trical connections on the ap-
pliance, please make sure that
the current-tap is provided
with ground connection and
that voltage values corre-
spond to those indicated on
the label placed inside the ap-
pliance itself.
* Before carrying out any clea-
ning or maintaining operations,
the appliance needs to be remo-
ved from the electric grid. If the
appliance is not provided with a
non-separable flexible cable and
plug, or with another device en-
suring omnipolar disconnections
from the grid, with an opening di-
stance between the contacts of
at least 3 mm, then such discon-
necting devices must be sup-
plied within the fixed installation.
If the fixed appliance is endowed
with a supply cord and a plug,
the appliance has to be put in a
place where the plug can be rea-
ched easily.
In order to avoid possible fire
risk, all instructions for grea-
se filter cleaning and for remo
ving eventual grease deposits
should be strictly followed.
Before carrying out the instal-
lation of the appliance, please
check that all components are
not damaged. In such a case,
make contact with your retai-
ler and do not proceed with
the in stallation.
If the product show any ano-
maly, disconnect the applian-
ce from the power supply.
12