Fulgor Milano INCOGNITO 85 Instrucciones Para La Instalación Y Uso página 14

Avoid abrupt direction changes. Use a 150mm
constant diameter pipe for the whole length. Use
piping approved standards in force.
Remove the fixing screws of the rear steel bar, as
shown in fig. 5.
Rotate the steel bar, including the led bar, to re-
move it from its seating (fig. 6- 7). You can electri-
cally disconnect the bar by acting on the specific
connector.
Place the appliance inside the cabinet and fix it
by inserting the screws supplied into the holes,
as shown in fig. 8.
Both in the front and rear side of the appliance.
Refit the stainless steel bar previously removed,
connect the led bar electrically by means of the
specific connector, and then refit the grease filter.
Rear air outlet
Models equipped with only one motor can be in-
stalled having the motor air out let oriented to-
wards the appliance rear side.
If you choose this option, you will need to remove
the motor support by removing the 18 screws (fig.
9), taking out and rotating the support, placing it
in its housing , always keeping the air outlet orien-
ted towards the appliance rear side. (fig. 10).
Secure it by using the screws previously remo-
ved.
If you intend to rotate the fan, in order to orient
the air outlet to the rear side of the product, you
must foresee the air outlet channeling at 238mm
distance from the lower surface of the wall unit
(fig. 11).
Blocking of the stop valve
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure the stop valve, which is on
the air outlet of the motor, can swing.
Exausting version
Connect the flange to the exhausting hole with an
appropriate pipe. Connect the appliance with the
electrical mains through the supply cord.
Filtering version
Connect the flange with a pipe suitable to con-
vey the air to the top of the cabinet. Connect the
appliance with the electrical mains through the
supply cord.
Chimney installation
Lift the internal steel chimney up to the top of the
wall unit (fig. 12), draw with a pencil the rear end
of the internal chimney on both
sides (fig. 13), lower the entire chimney and posi-
tion the fixing bracket in corresponden ce with the
marking made (fig. 14), secure the bracket with
screws (fig. 15).
Lift the internal chimney up to cover the bra cket
and secure it with screws positioned on both si-
des (fig. 16).
14