Publicidad
Idiomas disponibles
Idiomas disponibles
WORKING
Mod. SL TC – Glass (dis. 17)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function desired by
touching the relative key.
If the electrical power supply to the product SLTC is
cut, 15 seconds are needed for selfdiagnostics after
the functions are restored.
In the meanwhile, its operation may be incorrect.
The products are endowed with an electronic devi-
ce which allows the automatic switching off after 4
hours working from the last ope ration.
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer
de vice that automatically switches the suction
speed from 4th to 3rd speed, after 6 minutes ope-
ration.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel.
It can be removed by pushing its special handle
toward the back-side of the cooker hood and tur-
ning the filter downwards so to unfasten it from
its slot (Fig. 4).
To insert the filter just perform the opposite ope-
ration.
After 30 hours working (model), the push button
control panel will signal the saturation of the grea-
se filter by lighting all the buttons. Press the timer
button to reset
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
least or depending on its use.
* In case the appliance is used in its filtering ver-
sion, the active coal filter (Fig. 18) needs to be
periodically replaced. The coal filter can be re-
moved by removing the grease filter first (Fig. 4),
and by pulling its special plastic tongue until it is
unfastened from its slot. Re-insert the coal filter
by operating in the opposite way. The coal filter
needs replacing depending on the use, but howe-
ver every six months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated o the
product itself to obtain the desired results).
LED BAR REPLACEMENT
To remove the led bar , it is recommended to re-
move the steel bar as shown in Fig. 6 and 7, then
disengage the led bar by acting on the specific
fastening springs.
Replace the led bar with one of the same cha-
racteristics.
Refit the steel bar.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
15
.
Publicidad
