Warranty - Liberty Pumps 331 Manual De Usuario

Problem
Air leak in suction line.
Impeller blocked.
Impeller broken or worn.
Pump will not prime or
Suction lift too high.
retain prime after
operating.
Hose kinked, looped, or collapsed.
Fittings not tight.
Suction hose out of water.
Clogged inlet.
Piping or hose is clogged or damaged.
Narrow piping or hose diameter.
Flow rate is too low.
Low line voltage.
* Note: Liberty Pumps, Inc. assumes no responsibility for damage or injury due to disassembly in the field. Disassembly, other than at
Liberty Pumps or its authorized service centers, automatically voids warranty. All electrical work should be done by a qualified
electrician.

Warranty

Liberty Pumps Wholesale Products Limited Warranty
Liberty Pumps, Inc. warrants that Liberty Pumps wholesale products are free from all factory defects in material and workmanship for a
period of three (3) years from the date of purchase (excluding batteries). The date of purchase shall be determined by a dated sales
receipt noting the model and serial number of the pump. The dated sales receipt must accompany the returned pump if the date of
return is more than three years from the date of manufacture noted on the pump nameplate.
The manufacturer's sole obligation under this Warranty shall be limited to the repair or replacement of any parts found by the
manufacturer to be defective, provided the part or assembly is returned freight prepaid to the manufacturer or its authorized service
center, and provided that none of the following warranty-voiding characteristics are evident:
The manufacturer shall not be liable under this Warranty if the product has not been properly installed, operated, or maintained per
manufacturer instructions; if it has been disassembled, modified, abused, or tampered with; if the electrical cord has been cut, damaged,
or spliced; if the pump discharge has been reduced in size; if the pump has been used in water temperatures above the advertised rating;
if the pump has been used in water containing sand, lime, cement, gravel, or other abrasives; if the product has been used to pump
chemicals, grease, or hydrocarbons; if a non-submersible motor has been subjected to moisture; or if the label bearing the model and
serial number has been removed.
Liberty Pumps, Inc. shall not be liable for any loss, damage, or expenses resulting from installation or use of its products, or for indirect,
incidental, and consequential damages, including costs of removal, reinstallation or transportation.
There is no other express warranty. All implied warranties, including those of merchantability and fitness for a particular purpose, are
limited to three years from the date of purchase. This Warranty contains the exclusive remedy of the purchaser, and, where
permitted, liability for consequential or incidental damages under any and all warranties are excluded.
7000 Apple Tree Avenue
Bergen, NY 14416
ph: 800-543-2550
fax: 585-494-1839
www.libertypumps.com
– 6 –
Table 2. Troubleshooting Matrix
Possible Cause
Copyright © Liberty Pumps, Inc. 2018 All rights reserved.
Corrective Action
Replace suction line.
*Remove front plate and clean impeller area.
*Replace impeller – contact factory.
Lower pump or use a check valve near the bottom of the
suction line (maximum suction lift 15 ft).
Straighten hose or replace with heavier, reinforced hose.
Tighten fittings. Use new rubber hose gaskets.
Submerge suction hose and re-prime.
Clean inlet or suction screen at hose end.
Replace hose or check hose for kinks.
Replace hose with ¾" reinforced hose.
Check voltage. If under 108V, check wiring size.
Remove extension cord or use one with a heavier gauge.
7327000F