Blumfeldt 10029146 Manual Del Usuario página 9

Step 4: Joining together the upper and lower baskets
Step 5: Mounting the support bracket
Step 6: Insering the Cushions
If any items are missing or damaged, please request a replacement part from:
YAVE, Rübenkamp 25, 21220 Maschen
Fax: 04105/586404
Email: support@dahlmann.com
Please specify model & order number as well as your contact information.
Model No.: KD2-BBL-WAO
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
9
First, hold the upper rack
to the lower rack so that
the pre-assembled screw
plate located on the upper
basket is in the middle of
the two holes on the rail on
the lower rack.
Please make sure that you
do not tighten the bolts too
much, it should not rub or
scratch the wooden frame.
To assemble the support
bracket (11), please con-
nect the three individual
pieces with 2 screws (C).
Then the support bracket
is attached with the screws
and cap nuts (G) of the U-
profiles.
First insert the back
cushions down into the
hooks provided and then
press the pad the top of
the rear wall.
Now insert the adjustment
handle (E) in a hole on the
rail on the lower rack, hold
a plastic washer against
to the screw hole on the
upper rack and turn the
bolt through the positio-
ning handle and the plastic
washer in the upper basket.
To attach the support bra-
cket to the rear of the
upper basket, you must
first mount the U-profiles
(H) with 2 screws (C) at the
marked points.
Please make sure that the
support bracket can swing
freely.
When inserting the seat
bench, ensure that the gui-
de bar is facing forward and
that the cushion is positi-
oned properly.