Philips AT620 Manual De Usuario página 2

English
introduction
Congratulations on your purchase and welcome to Philips! To fully benefit
from the support that Philips offers, register your product at
www.philips.com/welcome.
Please read this user manual, as it contains information about the wonderful
features of this shaver as well as some tips to make shaving easier and more
enjoyable.
general description (Fig. 1)
1 Shaving unit
2 Shaver on/off button
3 Charging light
4 Socket for small plug
5 Small plug
6 Adapter
7 Trimmer (AT620 only)
8 Trimmer release slide (AT620 only)
9 Guard
10 Cutter
11 Retaining frame
Note: You can find the type number on the back of the shaver.
important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
- Make sure the adapter does not get wet (Fig. 2).
Warning
- The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
- This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
- Always unplug the shaver before you clean it under the tap.
Caution
- Never use water hotter than 80°C to rinse the shaver.
- Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
- The shaver is not dishwasher-proof.
- Water may leak from the socket at the bottom of the shaver when you
rinse it. This is normal and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
- Do not use the shaver or adapter if it is damaged, as this may cause injury.
Always replace a damaged adapter or part with one of the original type.
- Use, charge and store the appliance at a temperature between 10°C
and 35°C.
- Always place and use the shaver on a surface that is fluid-resistant.
- Only use the adapter supplied.
- If the shaver is subjected to a major change in temperature, pressure or
humidity, let it acclimatise for 30 minutes before you use it.
Compliance with standards
- This shaver complies with the internationally approved safety regulations
and can be safely used in the bath or shower and cleaned under the
tap (Fig. 3).
- This Philips appliance complies with all standards regarding
electromagnetic fields (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
general
- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
Charging
Note: The shaver cannot be used directly from the mains.
When you charge the shaver for the first time or after a long period of
disuse, let it charge for at least 10 hours.
A fully charged shaver provides up to 30 minutes of shaving time.
The shaving time may be less than expected as a result of your shaving
behaviour, your cleaning habits or your beard type.
Charge indications
Battery low
- When the battery is almost empty (when there are only 5 or fewer
shaving minutes left), the charging light lights up orange. When you
switch off the shaver, the charging light continues to light up orange for a
few seconds (Fig. 4).
Charging
- When the shaver is charging, the charging light lights up green
continuously. (Fig. 4)
Note: The charging light will keep lighting up green when the shaver is fully charged.
Charging with the adapter
Put the small plug in the shaver.
1
Put the adapter in the wall socket.
2
Using the shaver
Note: This shaver can be used in the bath or shower. For safety reasons, the
shaver can therefore not be used from the mains.
shaving tips and tricks
- This shaver is suitable for both wet and dry use. Use the shaver with
shaving gel or foam for extra skin comfort, or use the shaver dry for
extra convenience.
Note: We advise you to use the shaver with shaving gel or foam when you use it
for a wet shave. Do not use thick shaving cream or shaving oil with this shaver.
- For optimal shaving results, make circular movements during use.
- The shaver is waterproof and can be used in the bath or shower.
- Your skin may need 2 to 3 weeks to get accustomed to the Philips
shaving system.
Wet shaving
Apply some water to your skin. (Fig. 5)
1
Apply shaving foam or shaving gel to your skin. (Fig. 6)
2
Rinse the shaving unit under the tap to ensure that the shaving unit
3
glides smoothly over your skin.
Press the on/off button once to switch on the shaver.
4
Move the shaving heads over your skin in circular movements. (Fig. 7)
5
Note: Rinse the shaver under the tap regularly to ensure that it continues to
glide smoothly over your skin.
After shaving, press the on/off button once to switch off the shaver
6
and dry your face.
Clean the shaver (see chapter 'Cleaning and maintenance').
7
Note: Make sure you rinse all foam or shaving gel off the shaver.
Dry shaving
Tip: Ensure your skin is fully dry so that the shaver glides smoothly over your skin.
Press the on/off button once to switch on the shaver.
1
Move the shaving heads over your skin in circular movements (Fig. 8).
2
After shaving, press the on/off button once to switch off the shaver.
3
Clean the shaver (see chapter 'Cleaning and maintenance').
4
Trimming (AT620 only)
You can use the trimmer to groom your sideburns and moustache.
Push the trimmer release slide downwards to open the
1
trimmer. (Fig. 9)
Press the on/off button once to switch on the shaver.
2
You can now start trimming.
,
After trimming, press the on/off button once to switch off the shaver.
3
Clean the trimmer (see chapter 'Cleaning and maintenance').
4
Close the trimmer ('click') (Fig. 10).
5
Cleaning and maintenance
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the shaver.
Always unplug the shaver before you clean it under the tap.
- Clean the shaver after every shave for optimal shaving performance.