Installing A Guest Laptop Connection - smart Board 8070i Guia De Instalacion

I N S T A L L I N G Y O U R I N T E R A C T I V E D I S P L A Y
I
I M P O R T A N T
Your room computer must be connected to your interactive display with a VGA cable. If
you connect to it with another video input, you will not have touch control.
2. Connect the included USB cable from the USB #1 connector on the inside connection
panel of the interactive display to a USB 2.0 connector on the computer.
I
I M P O R T A N T
Do not connect you room computer to the USB #2 connector on the interactive display. If
you do, you will not have touch control for the room computer.
3. Connect the included power cable from the AC IN connector on the interactive display
bottom terminal panel to the AC power outlet.
4. Connect the power cable from your computer to the wall outlet.
5. Press the main power switch on the bottom terminal panel to the on position, and then
press the power button
6. Using the infrared remote control or the input button
input source to VGA.
7. Turn on your computer.

Installing a guest laptop connection

You can install cabling from the interactive display that will enable you to connect a laptop to your
interactive display. When you change the input source on the interactive display, you will have
touch control over the laptop's desktop.
N
N O T E
You do not require a laptop to install this cabling.
You require a USB cable and a VGA to RGB/HV cable to install the guest laptop connection. A
wire bundle that includes these two connectors is available from your authorized SMART
reseller. Refer to the interactive display specifications document for ordering information.
W
W A R N I N G
Ensure that any cables extending across the floor to your SMART product are properly bundled
and marked to avoid a trip hazard.
7 | 99-01112-2 A0
on the front control panel..
on the front control panel, set the