Selecting The Mounting Location - smart Board 8070i Guia De Instalacion

I N S T A L L I N G Y O U R I N T E R A C T I V E D I S P L A Y
Attach the included M12 eyebolts and washers to assist in mounting.
l
W
W A R N I N G
In order to aid in mounting or carrying, a lifting device must be used in conjunction
o
with the M12 attachable eyebolts. Do not attempt to mount or carry the display
using your own strength because the display may fall and cause personal injury.
Use VESA-approved mounting hardware. Remove the M12 eyebolts after
o
installation.
Inspect the installation location to ensure that it can support the weight of your interactive
l
display.
Use M8 screws to fasten the wall bracket. The length of the screws must be 14-15 mm
l
plus the thickness of the bracket and the washer. If using screws longer than 14-15 mm,
ensure sufficient depth.
Recommended fasten force is 1125-1375 N·cm
l
Refer to the instructions included with the mounting equipment for more detailed
l
information.

Selecting the mounting location

Consider the following when you select a location for your interactive display:
The wall must be strong enough to support your interactive display and the mounting
l
accessories. Your interactive display weighs 262 lb. (119 kg).
Do not install your interactive display in a location where a door or gate can hit it.
l
Do not install your interactive display in an area where it will be subjected to strong
l
vibrations or dust.
Do not install your interactive display near where the main power supply enters the
l
building.
3 | 99-01112-2 A0