Important Safety Instructions - Remington MB320C Manual De Usuario

ENGLISH
REPLACING THE CUTTER ASSEMBLY
Hold the trimmer in one hand. With your other hand, insert the lower part of the cutter
assembly into the trimmer, push down the cutter until fi rmly attached.
REPLACING THE TRIMMER COMB
Hold the trimmer in one hand with your thumb fi rmly on the zoom wheel to keep it from
turning. Ensure that the length position indicator is at 1.
Slide the comb/shaver down the grooves until it clicks into place.
Note: The trimmer comb attachment can only be placed on the trimmer one way; if it
does not fi t properly remove and reverse it.
Tips for best results
Beard, moustache and sideburn hairs should be dry.
Avoid using lotions before using your trimmer. Comb your hair in the direction that it
grows.
Remove trimmer comb attachment if you are: defi ning hairline edges such as sideburns,
trimming the nape of your neck, trimming your beard line on front of neck.
CARE FOR YOUR TRIMMER
CLEANING AND MAINTAINING YOUR TRIMMER
Care for your trimmer to ensure a long lasting performance. Your trimmer is fi tted with
high-quality, diamond like carbon coated cutting blades that are permanently lubricated.
Cleaning should only be done with a soft brush.
After each use
Turn the trimmer off.
Remove trimmer comb attachment and cutter assembly.
Gently brush the remaining hairs away from the trimmer comb and trimmer blade.
Do not rinse the cutter assembly under water.
POP-UP TRIMMER
Remove the trimmer comb attachment.
Slide up the pop-up trimmer into operating position (DIAGRAM F)
Brush hair from the trimmer blades and the surrounding area.
4
061175_REM_IFU_MB320C.indd 4-5 061175_REM_IFU_MB320C.indd 4-5
CLEANING CAUTIONS
Only the trimmer comb attachment and trimmer blade may be removed from the product
for cleaning.
Cleaning should only be done with a soft brush, such as the brush supplied with the
product.
Do not use harsh or corrosive cleaners on the units or their blades.
This trimmer is not washable. Do not rinse under water.
Do not submerge in water as damage will occur.
STORAGE
Always store this appliance and cord in a moisture-free area. Do not store it in temperatu-
res exceeding 140°F (60°C).
Do not wrap the cord of the charging adaptor around the appliance.
TROUBLESHOOTING
The trimmer does not work when turned on:
Trimmer must be charged for a full 14-16 hours. If this does not work, contact Remington
Service Centre.
Trimmer blades does not move:
The cutting unit may be dirty and clogged.
Clean and lubricate the unit.
Trimmer does not hold charge:
Fully discharge battery by running trimmer until it stops; then follow recharging instruc-
tions. If time between recharging cycles does not increase, battery may need replacing.
®
Contact Remington Service Centre.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION,
FIRE, OR INJURY TO PERSONS:
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not use the product with a damaged cord. A replacement can be obtained from an
International Service Centres listed at the back of this booklet.
Use and store the product at a temperature between 15°C and 35°C.
Only use the parts supplied with the appliance.
®
5
21.11.2006 16:52:27 Uhr 21.11.2006 16:52:27 Uhr