Names And Functions Of Each Part - Hitachi RAK-18PSB Manual De Instrucciones

NAMES AND FUNCTIONS OF EACH PART

INDOOR UNIT
Air Outlet
Pipe/Wiring
OUTDOOR UNIT
Drain Port (bottom)
Air Outlet
Discharges cool air when in heating
mode and warm air when in cooling
and dry cool modes, and warm or
cold air when in the dehumidifying
mode.
• While the power is on, a very small amount of power is
consumed within the control circuit even when the unit
is not in operation.
Power can be saved if the circuit breaker is switched off.
• Operation temperature of outdoor is -20°C to 43°C.
All manuals and user guides at all-guides.com
ECO Sensor
Ion Mist Unit
Remote Controller
(Please refer to
Remote Controller
Manual)
Drain Hose
Drains dehumidified water generated from the indoor unit when in
the cooling, dehumidifying and dry cool modes.
Air Inlet (rear and left side)
Earth Terminal
(side bottom)
– 4 –
(Understanding The Operating Mechanism, page 14)
Front Panel
(Page 6)
Signal Receiver (internal)
Receive signal from the
remote controller.
Temporary Operation Switch
(Forced Cooling Switch)
Indicator
Horizontal/
Vertical Air Deflector
(internal)
ABOUT OUTDOOR UNIT
• Even if the operation is stopped, the outdoor
unit fan continues to rotate for 10~60 seconds
to cool down the electrical parts.
• In heating operation, condensed water and
defrosted water is discharged from the outdoor
unit. Do not block the drain port as the water in
the drain may freeze in a cold area.
• Even during cooling operation, the water
condensed in the pipe, etc. may flow out from
the outdoor unit.
• When installing the outdoor unit under eaves,
etc. of the apartment, install a bush and drain
pipe on the drain port for drainage treatment.
CAUTION
Turn off the circuit breaker if the unit is not
in use for a long period.