Turning On The Display And Other Equipment; Setting Up The Remote Control - Sony MFM-HT75W Manual De Usuario

For VIDEO 1/VIDEO 2
S video cable (not supplied)
audio cord (not supplied)
video and audio cable (not supplied)
5
to AC IN
to power outlet
6
power cord (supplied)
Note
When you connect video equipment to both composite video
input and S video input jacks, the signal from the S video jack
is displayed.
Turning on the display and other
equipment
Turn on your display first, then a computer or other video
equipment.
1
Press the 1 (power) switch on the front of the
display.
The 1 (power) indicator lights up in green.
2
Turn on the computer or other video equipment.
3
Press the button to select the desired input
signal.
4
(US)
component video cable
(not supplied)
3
to VHF/
UHF
4
75-ohm coaxial cable (supplied)
3
CH
1
lights in green
The input signal will change each time you press the
On-screen message
DVI-D: PC 1
HD15: PC 2
TV Channels
: VIDEO 1
or : VIDEO 2
Note
When using the PIP function, if you switch the input using the
or input select buttons, the PIP function may be released. If it happens, the
input source that you have selected fills the entire screen. To use the PIP
function again, set the "PIP Setting" menu to "PIP On" using the menu
system or select "PIP On" by pressing the
Tips
• You can also select the inputs using the input select buttons on the
remote control.
• When you select the TV input, the number of the selected channel is
displayed in the upper right corner of the screen.
• When using the PIP function, use "Sub" in the "PIP" menu in the
"Option" menu to select the input source for sub picture. If the TV input
is selected for sub picture, you can change the channel using the CH +/
– buttons.

Setting up the remote control

Insert two size AAA batteries (supplied) by matching
the + and – marks on the batteries to the diagram inside
the remote control's battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery leakage
whenever you anticipate that the remote control will not be used for an
extended period.
• Handle the remote control with care. Avoid dropping it, getting it wet,
or placing it in direct sunlight, near a heater or where the humidity is
high.
button.
Input signal configuration
DVI-D input connector (digital
RGB) for PC 1
HD15 input connector
(analog RGB) for PC 2
TV
Y/P /P Component Video
B R
input jacks for VIDEO 1
Composite/S video input jacks
for VIDEO 2
button
button.