Assembly Instruction - Sunny Health & Fitness SF-E905 Manual De Usuario

Ocultar thumbs Ver también para SF-E905:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).

ASSEMBLY INSTRUCTION

STEP 1:
Attach the Front Stabilizer (No. 2) and
Rear Stabilizer (No. 3) onto the Main
Frame (No. 1), secure with 4 Carriage
Bolts (No. 6), 4 Arc Washers (No. 7)
and 4 Domed Nuts (No. 8) which are
preattached to the stabilizer, tighten with
Spanner (No. 105).
Note: Ensure that all bolts and washers
are in place and partially threaded in
before completely tightening any of
them.
STEP 2:
A: Connect the Lower Sensor Wire
(No. 16) to the Upper Sensor Wire (No.
15), and then connect Tension Hook
(No. 17) with Tension Cable (No. 10b)
as shown in Diagram A.
Note:
Make
Controller (No. 10a) is at the lowest
level before you connect the Tension
Cable (No. 10b). This ensures the wires
are
at
recommend the assistance of a second
person to help hold the Handlebar Post
(No. 9). This will make the connection
easier when you are attaching Tension
Hook (No. 17) to Tension Cable (No.
10b).
B: Remove the preassembled 4 Allen
Bolts (No. 13) and 4 Arc Washers (No.
14) from the Handlebar Post (No. 9).
Insert the Handlebar Post (No. 9) into
the post of the Main Frame (No. 1);
secure with 4 Allen Bolts (No. 13) and 4
Arc Washers (No. 14) that were just
removed with Wrench (No. 103).
Note: Ensure that all bolts and washers
are in place and partially threaded in
before completely tightening any of
them.
10
sure
the
Tension
their
longest
point.
We

Publicidad

Tabla de contenido
loading

Tabla de contenido