Sunny Health & Fitness SF-E905 Manual De Usuario página 12

Ocultar thumbs Ver también para SF-E905:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
IMPORTANT: Hinge Bolt (No. 19L/R) is labeled L for LEFT and R for RIGHT.
Please make sure to turn Left Hinge Bolt (No. 19L) counter-clockwise and Right
Hinge Bolt (No. 19R) clockwise.
The Hinge Bolt (No. 19L/R) must fully penetrate the nylon ring of the Nylon Nut
(No. 40L/R). This will ensure the stability and durability of your Elliptical Trainer.
The LEFT Nylon Nut (No. 40L) is SILVER, while the RIGHT Nylon Nut (No. 40R)
is BLACK. Please make sure to turn Left Nylon Nut (No. 40L) clockwise and
Right Nylon Nut (No. 40R) counter-clockwise.
In order to install the Hinge Bolt (No. 19L/R) properly, it must go through the
Connecting Joint (No. 52) and then screw into the hole of the Crank Arm (No.
49). Then attach Spring Washer (No. 39) and Nylon Nut (No. 40L/R) to the end
of Hinge Bolt (No. 19L/R). If the hinge bolt is connected to the crank arm at an
angle, damage to both the hinge thread and the crank arm may occur.
STEP 3:
A: Attach the 2 Swing Bars (No. 24L/R)
to the long axle of the Handlebar Post
(No. 9) with 2 Hex Bolts (No. 25) and 2
Flat Washers (No. 26) with 2 Spanners
(No. 104).
Note: Please do not fully tighten at this
time.
B: Attach the 2 Pedal Support Tubes
(No. 18L/R) to the Crank Arm (No. 49)
with 2 Hinge Bolts (No. 19L/R), 2 Wave
Washers (No. 61), then put on 2 Spring
Washers (No. 39) and 2 Nylon Nuts (No.
40L/R) to the end of 2 Hinge Bolts (No.
19L/R) using Wrench (No. 102) and
Spanner (No. 105).
Note: Please do not fully tighten at this
time.
C: Fasten the 2 Swing Bars (No. 24L/R)
and the 2 Pedal Support Tubes (No.
18L/R) tightly with 2 Hex Bolts (No. 21), 2
Flat Washers (No. 22) and 2 Nylon Nuts
(No. 23) using 2 Spanners (No. 104).
D: Fasten 2 Hex Bolts (No. 25) and 2
Nylon Nuts (No. 40L/R) tightly now. Then
cover with the 12 Nut Caps (No. 20 & 58
& 57 & 41).
Note: Ensure that all bolts and washers
are in place and partially threaded in
before completely tightening any of them.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido