T-Fal And Your Frequently Asked Questions - T-Fal INSFTW1 Guia Del Usuario

T-fal and Your Frequently Asked Questions

Problems
If the pressure cooker has
heated up under pressure
with no liquid inside:
If the pressure indicator
did not rise and nothing
escapes from the valve
during cooking:
If the pressure indicator
has risen but still nothing
escapes from the valve
during cooking:
If steam escapes from
around the lid, check:
If food has burnt on the
bottom of the pressure
cooker:
If you cannot open the
lid:
If food is not cooked or
has burnt, check:
Recommendations
• Have your pressure cooker inspected by a T-fal
Approved Service Center.
• This is normal for the first few minutes.
• If the problem persists, check that:
- There is enough heat, if not, turn up the heat.
- The amount of liquid in the pressure cooker is ade-
quate.
- The operating valve is set to
- The pressure cooker is properly closed and the ope-
ning button is in the
- The lid gasket has not perished.
• This is normal for the first few minutes.
• If the problem persists, place your appliance under cold
water. Then open it.
• Clean the operating valve and valve seat
check that the safety valve can be pushed in without
difficulty - Fig 12.
• That the lid is properly closed and the opening button
is in the position.
• The gasket is correctly fitted into the lid.
• That the gasket is in good condition, and if necessary,
replace it.
• That the lid, the gasket, its seat in the lid, the safety
valve and the operating valve are clean.
• That the rim of the pressure cooker body is in good
condition and not damaged.
• Leave the pressure cooker to soak for a while before
washing.
• Never use bleach or chlorine products.
• Check that the pressure indicator is down.
• If not, release pressure and if necessary cool the pres-
sure cooker under a stream of cold water.
• The cooking time.
• The heat level.
• Whether the operating valve was in the right position.
• The amount of liquid.
or .
position.
- Fig 8
EN
ES
ES
PT
EL
AR
FA
and
11