System Settings - Ampro Neo RDM Tester Manual De Usuario

15. SYSTEM SETTINGS

1. Device name
2. Backlight brightness
3. Turn off if idle
4. Date
5. Time
6. IP address
7. Net mask
8. Network Universe
9. Network Protocol
10. Default Settings
11. Firmware Version
12. Touch screen calibration
P. 14
Neo RDM Tester -
English version
Rename the device
Adjust the brightness of the backlight:
Press [enter] button or click this item directly to change the backlight bright-
nessfrom 10% to 100% in steps of 10%.
Set the idle time after which the fixture will turn off automatically when
battery operated. Possible values are: NO = stays on, 1min, 2min, 3min, 5min,
10min. The time is reset to zero whenever a button of the keypad is pressed.
This fixture will not turn off automatically when it's USB powered.
Set the date
Set the time
Set the IP address
Set the Net mask
Set the Universe
Select the network protocol
Factory Setting
Firmware Version
Touch screen calibration