Reversing Door Swing; Removing The Door - KENMORE ELITE 41791100002 Instrucciones De Instalación

1. Be sure you have adequate swing area before
reversing door.
2. You will need a screw driver with a #2 square
and straight bit.
3. Protect fl at work surface, such as top of dryer or
fl oor near dryer, with a soft cloth or towel.
4. Be sure dryer is unplugged from power source!

Removing the door

1. Open dryer door and remove the 4 hinge screws.
2. Supporting door with both hands, squarely slide door
and hinge outward approximately 3/8" (10 mm) so
hinge can be pulled from
shoulder bolts on front
panel.
Do not attempt
to remove the 2
shoulder bolts.
3. Gently place dryer door face down on fl at, covered
work surface.
4. Remove 2 pan head screws and door strike from inner
door.
1
2
3
4
1
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in personal
injury or even death.
5. Locate the 15 indented head screws - 8 in the small,
circular recesses at top and bottom edge of the inner
door, 2 on the latch-side edge, and 5 on the hinge-side
edge. Remove and save these 15 screws.
1
2
15
14
13 12
IMPORTANT
Do not attempt to remove the 2 "tamper-resistant"
screws that hold the inner glass in place.
6. Separate inner door assembly from outer door
assembly.
2
HINGE
IMPORTANT
DO NOT remove the hinge or strike support block.
21

Reversing Door Swing

Tools needed:
Screwdrivers with
#2 square &
straight bit
4
3
11 10
9
5
6
7
8
STRIKE
SUPPORT
BLOCK