Changing The Direction Of The Door Opening - Amica BK316.3FA Instrucciones De Operación

CHANGING THE DIRECTION
OF THE DOOR OPENING
Changing the direction of the door opening (Fig. 20)
1. Before reversing the door opening direction, unplug the appliance
and remove all food.
2. Using a flat screwdriver pry and remove hinge caps.
3. Using a Phillips screwdriver remove the door upper hinge while
holding the door (Fig. 20.1).
4. Using a Phillips screwdriver remove the middle hinge while holding
the upper door*
5. Set the door aside in a safe place.
6. Tilt the appliance (up to 40 degrees) so as to have sufficient access
to the lower hinge (Fig. 20.2).
7. Using a Phillips screwdriver remove lower door hinge
8. Attach the lower hinge on the other side (Fig. 20.3).
9. Position the door assembly in such a way so that pin of the lower
hinge is aligned with the appropriate hole of the lower door brack-
et.
10. Attach the middle hinge on the other side of the appliance so that
the lower pin of the middle hinge is aligned with the appropriate
hole of the upper door bracket. Position the second door assembly
so that the upper pin of the middle hinge is aligned with the appro-
priate hole of the lower door bracket.*
11. Attach the upper hinge so that the hinge pin is aligned with the
appropriate hole of the upper door bracket.* (Fig. 20.4).
12. Check that doors are properly aligned with the appliance body.
13. Replace the hinge caps.
14. Switch on the appliance as described in the relevant section of its
operating instructions.
* This action applies to appliances with both refrigeration and freezer
chambers.
- 54 -