Warning Information - Napa CARLYLE TOOLS 791-7125A Instrucciones De Operación

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using this tool. It is also the responsibility of the tool
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible,
contact NAPA for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed
with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends
its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of engine support tools is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise
of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and operation of the
equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use. Examples of haz-
ards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading, off-centered loads, use on other
than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study carefully, and understand the operating manual packed with this device before operating.
• Inspect before each use. Do not use if damaged, altered, modified, in poor condition or has loose or missing components.
Take corrective action before using.
• Do not exceed rated capacity.
• This product was not designed to lift an engine but rather support the engine when lifted by other means.
• Consult the vehicle manufacturer for the proper positioning and attachment of the product to the engine.
• Wear eye protection that meets ANSI Z87.1 and OSHA standard (users & bystanders)
• Make sure the engine is properly and safely supported before removing the lifting device from the engine.
• Stay clear of lifted load. Never crawl under the suspended load for any reason.
• Do not exceed maximum width of 61".
• No alterations shall be made to this device.
• Make sure the weight of the tool and engine can be supported by that part of the vehicle the tool is resting.
• Do not use this tool for any purpose other than for which it was designed.
• Make sure tool foot contact points can support the load
• Use only replacements parts approved by the manufacturer.
• Failure to heed these warnings may result in personal injury, property damage, or both.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
791-7125A
OPERATING MANUAL FOR 791-7125A
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
04/27/20