Warning Information - Napa CARLYLE TOOLS 791-2002A Instrucciones De Operación

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of the stand
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact
NAPA for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator
in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use
and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper
use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• This stand is intended to assist in supporting under vehicle components, not the vehicle.
• Inspect the stand before each use. Do not use if damaged, altered, modified, in poor condition or has loose or missing hardware or
components. Take corrective action before using the stand.
• Center load on saddle.
• Adequately support the vehicle before starting repairs.
• Be sure vehicle, vehicle components and stand are stable before performing any work.
• Do not use stand beyond its rated capacity. Do not shock load.
• Use only on a hard level surface capable of supporting the load.
• Use stands in pairs to stabilize the vehicle before starting repairs.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
• Failure to heed these warnings may result in personal injury, property damage, or both.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
SETUP
1. Screw the base tube (#7) in the base (#1) until tight.
2. Install the spring pin (#12) in the screw rod (#13). Feed the screw rod through the bottom of the post (#9) all the way until it sticks out
at the top of the post.
3. Place the Bearing (#14) on the screw rod (#13) and then screw the handle (#16) on the screw rod (13).
791-2002A
OPERATING MANUAL FOR 791-2002A
Do not use ends of saddle to support or stabilize load.
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
Rev. 04/09/20