Axxess AX-MB1 Instrucciones De Instalación página 3

INSTALLATION
With the key in the off position:
• Connect the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness into the interface, and then to the
wiring harness in the vehicle.
PROGRAMMING
Attention! If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an ASWC-1 connect it after you initialize and test the interface/
radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
Note: If using the ASWC-1, connect it after you initialize the AX-MB1, with the key in the off
position.
3
REV. 9/3/2020 INSTAX-MB1