FLORABEST 330843 1907 Instrucciones De Montaje página 26

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Note! Product assembly
requires at least 2 persons.
We recommend assembly
with 4 persons.
Step 1
Remove the article from the storage
bag.
Step 2
Slowly and evenly extend the
article at the opposite corners
(Fig. B and C).
Step 3
Slide the corner joints (2) for each
corner as far up until the locking pin
on the corner poles locks in (Fig. D).
Note! Great resistance in-
dicates the article is not yet
extended far enough.
Attention! Pinching hazard at
the corner joint!
Step 4
Extend the telescoping feet (10) in
the corner poles. To do so, place
one foot onto the base plate (4) of
the feet and slide the upper part of
the corner pole up until you hear the
telescoping foot lock in (Fig. E).
Note! You may choose from 3
height settings.
Step 5
Tighten the corner tarps (6) by
securing the factory installed hooks
(7) in the designated opening on the
telescoping foot (Fig. F).
28
GB/MT
There are 3 openings to choose
from:
When the telescoping foot is locked
into the lowest position, also secure
the hook in the lowest position.
When securing the telescoping foot
in the middle or top position, also
select the respective middle or top
opening.
Step 6
Anchor each telescoping foot using
the included tent pegs (3) using the
openings in the base plate (Fig. G).
Caution! Verify the tent pegs
are firmly secured.
Step 7
Knot one guy line (5) into each loop
(13) on the outside corners of the
article (Fig. G).
Tauten the lines and secure the ends
with the V-tent pegs (8) (Fig. G).
Caution! Again be sure the
tent pegs are securely an-
chored.
Step 8
Secure the side walls (9, 11) to the
pavilion corner poles / telescoping
poles (15) and crossbars (14) using
the factory installed hook and loop
fasteners (12) (Fig. H).
Note! When fastening be sure
the wrapped seam on the
edges of the side walls faces
inward.

Publicidad

Tabla de contenido
loading

Tabla de contenido