JB Systems Light LED Seawave Manual De Instrucciones página 6

ENGLISH
 To prevent strange behavior of the light effects, due to interferences, you must use
a 90Ω to 120Ω terminator at the end of the chain.
 Never use Y-splitter cables, this simply won't work!
 Make sure that all units are connected to the mains.
 Each light effect in the chain needs to have its proper starting address so it knows
which commands from the controller it has to decode.
Unfortunately it is impossible to tell you in this user manual which starting addresses you have to set
because this completely depends on the controller you will use... So please refer to the user manual of
your DMX-controller to find out which starting addresses you must set.
DMX-CONFIGURATION
OPERATE THE UNIT BY CA8
When used in standalone or master/slave mode we strongly advise you to use the CA-8
"Wired easy controller".
Just connect the controller to the hack input of the first unit (Master unit).
STAND BY To blackout all the fixtures
FUNCTION Wave speed:1-3 Choose color : 1-12
MODE LED OFF LED ON
JB SYSTEMS
®
OPERATION MANUAL
Color speed:1-3
LED blinking
7/41 LED SEAWAVE 50W
ENGLISH
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input: AC 100-240V ~ 50/60Hz
Power consumption: 80 Watt
Fuse: 250V T6.3A slow blow (20mm glass)
DMX connections: 3pin XLR male / female
DMX channels used: 3 channels
Lamp: 50W LED
Size: 27.9 x 22.6 x 19.1 cm
Weight: 4 kg
The information might be modified without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
OPERATION MANUAL
8/41 LED SEAWAVE 50W