Cleaning And Maintenance; Transmission Lubricant; Maintenance And Cleaning; Cleaning Tiller - Remington GARDEN WIZARD 109312-01 Manual Del Propietário

Ocultar thumbs Ver también para GARDEN WIZARD 109312-01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEANING AND MAINTENANCE

WARNING: Unplug tiller from
power source before cleaning or
servicing. Severe injury or death
could occur from fi re, electrical
shock, or body contact with mov-
ing tines.
WARNING: When cleaning
tiller:
• Do not submerge tiller in any
liquids.
• Do not use products that
contain ammonia, chlorine, or
abrasives.
• Do not use chlorinated cleaning
solvents, carbon tetrachloride,
kerosene, or gasoline.

CLEANING TILLER

1. To clean front and rear cover and
fender, use a soft cloth dampened with
a mild soap and water mixture. Do not
spray or pour water directly onto the
front or rear cover. Wipe the front and
rear covers and fender with the damp-
ened cloth.
2. To remove soil and debris from the
tines and transmission, use a stiff brush
or a dampened cloth. Do not spray or
pour water directly onto tiller.
3. For easier cleaning, remove the tines
from the tine shaft. See Tine Removal
and Installation.
4. Once cleaned, wipe the tine shaft dry
and apply a light coat of oil to the shaft
before reinstalling the tines.
CHECKING TRANSMISSION
LUBRICANT
1. Unplug tiller from power source.
2. Locate the grease fi ller screw located
above the tine shaft on the right side of
the transmission (see Figure 13).
3. Lay the tiller on its left side. Remove
the right side tine sets for easy access
to grease fi ller screw. See Tine Removal
and Installation.
4. Clean the transmission to prevent dirt and
debris from entering the transmission.
5. Using a Phillips head screwdriver, re-
move the grease fi ller screw from the
transmission case.
6. If grease is not visible in the hole,
add a high-quality, automotive-grade,
petroleum-based grease using standard
grease gun. Place the nozzle of the
grease gun fi rmly against the rim of
the hole and add grease until it begins
to seep out around the edge of the
nozzle.
7. Reinstall the grease fi ller screw and
wipe away any excess grease.
8. Reassemble the tine sets. See Tine
Removal and Installation.
Grease Filler
Screw
Figure 13- Grease Filler Screw
11
OTHER SUGGESTED
LUBRICATION POINTS
Handlebar Adjustment Knobs: Oc-
casionally spray a silicone type lubricant
around the saddle bolts.
Tine Shaft: After each use, remove the
tines, clean the tine shaft with fi ne sandpaper
and apply a light coat of oil to the tine shaft.
This will make future tine installation and
removal easier.
www.remingtonpowertools.com

Publicidad

Tabla de contenido
loading

Tabla de contenido