Assembly - Remington GARDEN WIZARD 109312-01 Manual Del Propietário

ASSEMBLY

UNFOLDING AND ADJUSTING
HANDLEBAR
Unfolding Handlebar
1. Loosen handlebar adjustment knobs.
Rotate the handlebar into the operat-
ing position (see Figure 1). Do not
force handlebar. If there is binding,
continue to loosen adjustment knobs.
Be careful not to pinch power cord
between handlebar and lower handlebar
support.
2. Tighten handlebar adjustment knobs.
Handlebar
Handlebar
Adjustment
Knob
Lower
Handlebar
Support
Figure 1 - Unfolding Handlebar
Adjusting Height of Handlebar
The handlebar has two possible height set-
tings. The tiller is shipped with the handlebar
mounted in the standard height or lowest
position. If this height is too short, adjust
the height of the handlebar to the extended
height or highest position.
1. Loosen and remove handlebar adjust-
ment knobs, washers, and saddle bolts
from handlebar.
2. Position handlebar so that the bottom
holes in the handlebar line up with the
holes in the lower handlebar supports
(see Figure 2). Insert the saddle bolts
through the holes and reinstall the
washers and handlebar knobs.
3. Tighten handlebar adjustment knobs.
Standard Height
Saddle
Adjustment Hole
Bolt
Handlebar
Adjustment
Knob
Extended Height
Adjustment Hole
Figure 2 - Adjusting Handlebar Height
7
Folding Handlebar For Storage
1 Loosen handlebar adjustment knobs.
Rotate the handlebar forward and down
over the tiller housing (see Figure 3).
Do not force handlebar. If there is
binding, continue to loosen knobs. Be
careful not to pinch power cord be-
tween handlebar and lower handlebar
support.
2 Tighten handlebar adjustment knobs.
Handlebar
Adjustment
Knob
Lower
Handlebar
Support
Washer
Figure 3 - Folding Handlebar Down
www.remingtonpowertools.com
Handlebar