Nebula Mars II Pro Manual De Usuario página 10

Specifications
Specifications are subject to change without notice.
Power supply: DC 19V 3A
Power consumption: < 57W
Standby power consumption: < 0.5W
Display technology: 0.3 inch 1280 × 720p DLP
Light source: RGB LED
Projection image size: 30 - 150 inch
Resolution: 1280 × 720 pixels
Brightness: 500 ANSI Lumens
Contrast ratio: 1000:1
Projection ratio: 1.2
Speaker drivers: 10 w × 2
Bluetooth: V4.2
Built-in battery type: Li-Polymer
Capacity: 3350 mAh 14.52V
Video play duration: 3 hours
Music play duration: 30 hours
Remote control batteries: CR2032 × 2
Operating temperature: 0°C to 35°C / 32°F to 95 °F
Operating humidity: 15% ~ 85% (non-condensing)
Storage temperature and humidity: < 65°C / 149°F, < 90% humidity
Dimension (W × H × D): 122 × 138 × 178 mm / 4.8 × 5.4 × 7 in
Weight: 1,483 g / 52.3 oz
16
Troubleshooting
① Fail to power on by the remote control?
• Make sure that the device is connected to the power supply.
• Slide down the lens cover.
② Fail to power on by sliding down the lens cover?
• Make sure that the device is connected to the power supply.
• Slide up the lens cover and wait for 10 seconds, then try again.
③ The remote control doesn't work?
• Remove the battery insulation tab to activate the remote control
batteries.
• Replace new batteries.
④ Blurred image?
• You can either slightly move the projector or press the navigation
buttons to focus on the image.
⑤ Reversed projection image?
• On the home menu, select [Settings] > [Projector mode] and switch to
the correct state.
17