Heath Zenith 4305 Manual De Instrucciones página 3

Bare Ground Wire
Ground Screw
Pigtail (not
supplied)
Fixture Bare
Ground Wire
Recommended Grounding Method
Black to Black
White to White
Ground to Ground
One Motion Sensing Light
Ground to
Ground
Two Motion Sensing Lights (Working Independently)
204063-02
Metal Junction
Box
White to White
Black to Black
Black to Black
White to White
Other Wiring Options
This fixture can be wired to control another standard
or motion sensing light fixture(s). See the following
wiring diagrams for proper connections.
Note: All wiring should be run in accordance with
the National Electrical Code through conduit or
another acceptable means. Contact a qualified
electrician if there is any question as to the
suitability of the system.
When controlling an additional light fixture(s), the
maximum wattage of the motion sensor on this
fixture should be observed. See illustration below
for an example of a maximum lamp wattage load
calculation.
Maximum Load for CONTROLLING Fixture
Motion Sensor –
500 Watts
CONTROLLED Fixture 1
CONTROLLED Fixture 2
IMPORTANT: When determining the maximum
lamp wattage rating of the fixture to be controlled,
refer to the maximum lamp wattage label on the
fixture and not the wattage rating on the lamp(s)
currently installed in the fixture.
White to White
Ground to
Ground
Motion Sensing
Light
Wiring Motion Sensing Light to Control Standard
3
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
TOTAL Load for
Motion Sensor –
300 Watts (200 Watts Remaining)
Black to Black
Red to Black
Standard Light
Fixture
Fixture