Phase - Monitor Audio Gold W15 Manual Del Usuario

Suggested Crossover Frequencies
Below is a table that shows suggested crossover frequencies
to set the Gold W15 to when partnering main speakers.
Type of Main Speaker
Large floor-standing speaker
Small floor-standing speaker
Large stand-mount/ bookshelf speaker
Small stand-mount/ bookshelf speaker
Small satellite speaker

Phase

The Phase Control is used to synchronise any delay between
the Gold W15 and main/ satellite speakers. When the Gold
W15 is in phase with the main/ satellite speakers the sound
should be full bodied. Sit in a normal listening position
whilst adjusting the phase settings. When set correctly the
location of the sub-woofer should be almost undetectable.
Experimentation is advisable. However it should be noted that
in most cases the phase control should be set to 0 degrees,
especially when using a digital AV processor or AV receiver
amplifier. The phase angle can be adjusted in steps of 0, 90,
180, 270, degrees.
Setting the Phase Using the Remote
With the Gold W15 powered up and out of standby mode, follow
the next steps to set the Phase:
1. Press the RIGHT arrow. The display will change to LPF
2. Press it a second time so the display changes to PHA
3. Press ENTER. The display will change to show the
current setting, eg. 0
4. Press the UP/ DOWN arrows to adjust the setting
5. Press ENTER to select and save. The display will flash
twice to confirm selection and then display PHA
Setting the Phase Using the Control
Panel Encoder
With the Gold W15 powered up and out of standby mode, follow
the next steps to set the Phase:
Crossover
Control Setting
1.
40-60 Hz
2.
50-70Hz
3.
50-80 Hz
60-90 Hz
4.
80-120 Hz
5.
EQ
There are four EQ options to choose from, Music, Movies,
Impact and Off. These can be set at any time in accordance
with personal choice or the predominant operation of the
system. They can also be selected and stored during the set
up process from the menu system.
During the set up they are numbered 1 - 3 and off. The
definitions and an example of the curve are below.
EQ 1: Music
EQ 2: Movies
EQ 3: Impact
Adjusting the EQ settings will change the perceived output
levels of the Gold W15. With this in mind, it is highly
recommended to run the auto set up of the AV Processor/
Receiver again.
monitoraudio.com
Press the encoder down. The display will change to LPF
Rotate the encoder 1 position to the right. PHA will be
displayed
Press the encoder again to enter the Phase menu. The
display will change to show the current setting, eg. 0
Rotate the encoder left or right to change the setting
Press the encoder to select and save. The display will
flash twice to confirm selection, and then display LPF
9