Brother PRSCLP45B Manual De Instalación página 5

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
● If the nuts are tightened too firmly when
removing the item from the frame after
embroidering, press the area between the
two screws with your fingers and use the
wrench included with the embroidery
machine to loosen the nuts.
Attaching the embroidery
frame
After hooping the item in the clamp frame, attach
the frame to the embroidery machine.
● When attaching or removing the clamp
frame, make sure that the start/stop button
of the embroidery machine is lit in red. If
the start/stop button is flashing in green,
the embroidery machine may start sewing.
If the embroidery machine accidentally
starts operating, injuries may result.
● Before attaching the clamp frame, install
embroidery frame holder D on the
embroidery machine.
1 Loosen and remove the two thumb screws
on the embroidery machine, and then
remove the embroidery frame holder from
the carriage.
1 Thumb screws
• The removed thumb screws will be used to
install embroidery frame holder D.
Memo
Note
2 Insert the pins on the frame-mounting plate
of the carriage into the holes on both sides of
the mounting plate of embroidery frame
holder D.
b
1 Pins on the frame-mounting plate of the
carriage
2 Holes in the mounting plate of embroidery
frame holder D
3 Install and tighten the two thumb screws
removed in step
Note
● Please firmly tighten the two thumb screws
with the disc-shaped screwdriver included
with the embroidery machine. The wrong
frame size may be indicated on the
machine's screen if the two screws are not
tightened.
3/4
a
1
.