2610056733 02-21 PS31_PS31 2/15/21 12:41 PM Page 11
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position (Fig. 1).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check
to make sure the gear shifting switch is
pushed fully into desired setting.
ADJUSTABLE CLUTCH
Your tool features 20 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 19. The drill "
position will lock up the clutch to permit
drilling and driving heavyduty work, and also
enables bits to be changed quickly and
easily in the keyless chuck (Fig. 7).
When the trigger switch is released it
activates the brake to stop the chuck
quickly. This is especially useful in the
repetitive driving and removal of screws.
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing
on both sides of the battery release tabs
and pull downward (Fig. 4).
To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force.
damaged, do not insert into tool. Battery can
fall out during operation.
BRAKE
If battery release tabs are
cracked or otherwise
AUTOLOCK™
Your tool is equipped with an automatic
locking system. This feature will lock the bit
holder in one position when the trigger switch
is released. This will allow you to tighten or
loosen a nut or screw by rotating the tool by
hand with the switch off. This is convenient
when higher turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that
turns on automatically when the switch is
activated, for better visibility when
drilling/driving (Fig. 7).
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition
"
indicator lights (Fig. 1). The indicator lights
shows the charge condition of the battery for
a few second when the On/Off trigger is
pressed halfway or fully.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
-11-
Capacity
> 2/3
> 1/3
< 1/3
reserve
FIG. 4
BATTERY
RELEASE
TABS