DeWalt DCS377 Manual De Instrucciones página 14

English
Any twisting or cocking of the blade will cause the cut to
go offline and decrease the life of the blade.
NOTICE: During cutting, if the band saw becomes
locked or jammed in the workpiece material, release
the switch immediately to avoid damage to the band
saw blade and motor.
5. The tool's own weight provides the most efficient
downward cutting pressure. Added operator pressure
slows the blade and reduces blade life.
6. End pieces, which would be heavy enough to cause
injury when they drop, after cut-off, should be supported.
Safety shoes are strongly recommended. End pieces may
be hot and sharp.
Recommended Cutting Positions
YES
YES
YES
Tips for Better Cutting
The following recommendations should be used as a guide
(refer to Recommended Cutting Positions). Results may vary
with the operator and the particular material being cut.
• Never twist the band saw blade during cutting operation.
• Never use liquid coolants with portable band saws.
Use of liquid coolants will cause build-up on tires and
reduce performance.
• If excessive vibration occurs during the cut, ensure that
the material being cut is is securely clamped down. If
vibration continues, change the band saw blade.
• Always keep at least 2–3 teeth engaged in the cut.
12
MAINTENANCE

Lubrication
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that
service is ever needed, take your tool to an authorized
service location.
Cleaning

NO

Accessories
NO

Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact D
visit our website: www.dewalt.com.
Tool Connect™ Chip (Fig. K)

Your tool is Tool Connect™ Chip ready and has a location for
installation of a Tool Connect™ Chip.
Tool Connect™ Chip is an optional application for your smart
device (such as a smart phone or tablet) that connects
the device to utilize the mobile application for inventory
management functions.
Refer to Tool Connect™ Chip Instruction Sheet for
more information.
installing the Tool Connect™ Chip
1. Remove the retaining screws
2. Remove the protective cover and insert the Tool
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
WALT call 1-800-4-D
e
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Connect™ Chip protective cover
Connect™ Chip into the empty pocket
WALT recommended
e
WALT (1-800-433-9258) or
e
22 that hold the Tool
21 into the tool.
.
23