Fuse; Mounting Bracket; X 16 Mm Self-Tapping Screw; M4 X 6 Mm Hex-Headed Screw With Washer - Kenwood NX-5000 Serie Guia Del Usuario

4 Mount the microphone hanger in a location where it will be within easy reach of
the user.
The microphone and microphone cable should be mounted in a place where they will
●
not interfere with the safe operation of the vehicle.
CAUTION
When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same rating.
Never replace a fuse with one that is rated with a higher capacity.

Spring washer

M4 x 6 mm
hex-headed screw
with washer
RF antenna connector
Using the microSD memory card
o
To install a microSD memory card on this transceiver, please consult your dealer.
microSD memory cards (Class 2 or higher) and microSDHC memory cards (Class 2 or
●
higher) can be used.
SDXC memory cards cannot be used.
●
This transceiver is not guaranteed to operate with all microSD memory cards.
●
(Operations are confirmed on memory cards for the following brands: SanDisk, TOSHIBA
and Panasonic.)
Compensation Disclaimer
Data stored on the microSD memory card may be altered or lost due to problems with this transceiver.
We do not accept liability in respect of the data stored on your microSD memory card, failure to save
the data properly, loss of data, and any direct or indirect damages.
8

5 x 16 mm Self-tapping screw

Flat washer

Ignition sense
cable
External
speaker jack
Black (–) cable
Red (+) cable
Microphone
GPS antenna connector
for KRA-40

Fuse

Mounting bracket

12 V vehicle battery