Honeywell QuickSTEAM HWM-330 El Manual Del Propietario página 7

QuickSteam_OM_04-25-06.qxd
Manual Control Operation (HWM-331)
NOTE: This product is equipped with a Vapor Mist Sensor
Badge
(Fig 10). When the Vapor Mist Sensor Badge located on
the medicine cup, turns from grey to blue warm moisture
is being emitted from the humidifier. Do not touch the medicine cup or warm moisture outlet grille
unless the unit has been turned off and the Vapor Mist Sensor Badge has turned back to grey.
EasySet ™ Control Operation (Model HWM-335)
P O W E R
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH
WET HANDS AS AN ELECTRICAL SHOCK COULD
OCCUR.
• With the power OFF, plug the filled humidifier into a polarized 120V
outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it
will only fit one way.
S T E P 1 : P O W E R
• Press the Power button to start the humidifier. Your humidifier will
automatically start on High power, continuous run (Fig. 11).
• To turn your humidifier OFF simply press the Power button again.
S T E P 2 : O U T P U T / M O I S T U R E C O N T R O L
Your unit has three output/moisture levels:
HIGH: For fast humidifying
MED: For everyday moisture control
LOW: For minimum operation (ideal for nighttime use)
• Push the Up button (+) to increase output level and push the Down
button (-) to decrease output level. The LED's will illuminate to
reflect which level you have selected (Fig. 12).
• Continuous Mode: Your unit will run continuously at your selected
output level until you shut it off or it runs out of water.
S T E P 3 : S E T H U M I D I T Y
• Set your desired humidity anywhere between 35% and 55%.
• Push the Up button (+) to increase desired humidity and push the
Down button (-) to decrease desired humidity. The LED's will
illuminate to reflect which desired humidity level you have selected
(Fig. 13).
For example: If you set your humidity at 40%, the 35% and 40%
LED's will be illuminated.
• Once you have set your desired humidity, the unit will operate under
this desired setting until the unit is turned off.
• When the desired room humidity has been reached the unit will automatically shut off. (The humidity
LED's will remain illuminated.)
• Your unit will turn back on when your room decreases beyond your set level.
NOTE: Your room humidity can often fluctuate. It is normal for your unit to turn itself on and off
throughout the day as it is monitoring your changing environment.
To go back to Continuous Mode, turn your unit off and then back on and select your desired output setting
(see Step 2).
4/25/06 4:53 PM Page 7
Fig. 10
Fig. 11
Moisture
Humidistat
Control
Control
Refill/
Clean
Light
Power
Reset
Button
Button
(On/Off)
Fig. 12
Fig. 13
7