Aqua Medic ECOplant LED Manual De Instrucciones página 9

Pict. 2: Steel wire suspension
1.1 Ceiling suspension
1.2 Stopper at the stainless steel cable
1.3 Nut for ceiling suspension
2.1 Lamp fixing
4.2. Mounting of the aquarium fitting
Pict. 3: Aluminium holder for ECOplant LED
1. Fittings
2. Brackets (adjustable in height)
3. Fixing screws for fittings
4. Allen screws for fixing the brackets
Available spare parts: Please refer to www.aqua-medic.de.
The brackets (pict. 3, No. 2) are pushed into the guide rails of the ECOplant LED. Then, the
requested height is adjusted by the Allen screws in the lateral openings (pict. 3, No. 4) of the
fittings. An Allen key for locking is included. The fittings (pict. 3, No. 3) are placed on the side
panes of the aquarium. The required distance is achieved by moving the brackets in the guide rails.
By using the fixing screws (pict. 3, No. 3) a safe hold is provided.
Pict. 4: Plastic holder for ECOplant LED
2.2 Safety bolt
2.1.1 Fixing screw for release
2.1.2 End of cable
9