Special Settings - Maurice Lacroix ML115 Manual Del Usuario Y Garantía

16
4. SETTINGS
4.1 STANDARD SETTINGS FOR
ALL WATCHES
Setting the time:
1. Pull the crown (I) right out completely to
position 2. The seconds hand will stop.
2. Set the time by turning the crown (I)
forwards or backwards.
3. To synchronise the watch with the official
time signal (radio, telephone, etc.), push the
crown (I) back into position 0 to coincide
with the given time signal.
After settings, always push the crown (I)
!
back into position 0 and avoid setting
the time under water to prevent moisture
from getting into the mechanism.
Setting the date and the day:
Calibre A|B|C|D|E|ML115|ML132
|ML155|ML143|ML113|ML112
1. Pull the crown (I) right out to position 1.
2. Depending on the movement type, turn
the crown (I) clockwise or anti-clockwise
and set the current date.
3. Turn the crown (I) in the opposite direction
to the date setting and set the day.
4. Push the crown (I) back into position 0.
Automatic watches: do not make any
!
adjustments when your watch shows
a time between 8 p.m. and 4 a.m.
If the watch has not been worn for 24
hours or more, wind it up with the crown
(I) in position (0).
Do not set the date and the day under
!
water to prevent moisture from getting
into the mechanism.

4.2 SPECIAL SETTINGS

Setting the date, the day and the month:
Calibre ML37
1. Set the date by activating the corrector
(IV) until the desired date is displayed by
the hand (D).
2. Press the corrector (V) until the desired
day of the week is displayed in (E).
3. Press the corrector (VI) until the desired
month is displayed in (H).
Setting the date, the day and the month:
!
correction is not possible between 10
p.m. and 1 a.m.
Setting the date:
Calibre ML57
Set the date by pressing the corrector/pusher
(IV) until the desired day is displayed in (D).
Quick date setting: correction is not
!
possible between 8 p.m. and 4 a.m.
Do not use the pusher (IV) under water to
prevent moisture from getting into the
mechanism.
Setting the moonphase:
Calibre C
There is no quick-change correction for setting
the moonphase.
1. Pull the crown (I) right out to position 2.
The seconds hand will stop.
2. Turn the hands forward by turning the
crown, until the current moonphase display
appears.
3. Push the crown (I) back into position 1 and
set the current date using the quick change
correction.
4. Push the crown (I) back into position 0.
Calibre ML37
1. Press the corrector (VII) until the full moon
appears in the centre of the
aperture (G).
2. Press the corrector (VII) as many times as
there are days that have passed since the
last full moon.
17