Selecting The Battery Type - Carson DRAGSTER SPORT BRUSHLESS SENSORLESS Instrucciones

8. Selecting the battery type

When the battery type is selected, the undervoltage protection
(NiCd/NiMH: at 4V or lower, two or three-cell LiPo: at 3.0 V per cell or
lower) is activated.
If you wish to drive without undervoltage protection (Cut-Off), you
must select 5 in the driver profile (reset to factory defaults) and
reconfigure the other parameters to your requirements again.
Flashing
frequency
Battery type
• Switch on the transmitter, then the controller!
• Press the SET button down until the red LED lights up. Release
the SET button.
• The red LED starts fl ashing.
This shows that you are in the mode for setting the battery type.
• Press the SET button again briefl y. This brings you to the next
setting.
The red LED fl ashes at the next highest speed.
• By repeatedly pressing briefl y on the SET button you can scroll
through the settings.
• When you reach the required setting, hold down the SET button
for approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs fl ash one after
the other to show that you are leaving the programming mode.
The controller is ready for
operation again.
• If you do not press the
SET button for more than
10 seconds the controller
reverts to the last setting
and is ready for use
again.
011847_anl_906056_regler_drag_7k13 13 011847_anl_906056_regler_drag_7k13 13
NiCd/NiMH
CARSON DRAGSTER Brushless-Regler 906008+906056
1 2
LiPo
(2 cells)
GB
3
LiPo
(3 cells)
13
04.03.2008 11:45:13 Uhr 04.03.2008 11:45:13 Uhr