Setting The Maximum Brake Performance - Carson DRAGSTER SPORT BRUSHLESS SENSORLESS Instrucciones

10. Setting the maximum brake performance

Flashing
frequency
Brake
performance
(%)
• Press the SET button down until the blue and green LEDs light up.
Release the SET button again.
• The blue and green LEDs start fl ashing.
This shows that you are in the mode for setting maximum brake
performance.
• Press the SET button repeatedly until you reach the required
setting.
The blue and green LEDs fl ash at the next highest speed.
• By repeatedly pressing briefl y on the SET button you can scroll
through the settings.
• When you reach the required setting, hold down the SET button
for approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs fl ash one after
the other to show that you are leaving the programming mode.
The controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
011847_anl_906056_regler_drag_7k15 15 011847_anl_906056_regler_drag_7k15 15
1
10 20
CARSON DRAGSTER Brushless-Regler 906008+906056
2 3 4 5
30 40 45
6 7 8 9
50 55 60 65
04.03.2008 11:45:14 Uhr 04.03.2008 11:45:14 Uhr
10
70
GB
15