Thermador SGS304FS Manual Del Usuario página 4

ASSEMBLE NEW ORIFICES in
place on the cooktop exactly as
layed out in the orifice package card
as shown in Figure 5. Place the
new orifices into the socket one at
a time (the tape will keep them in
place), then insert each orifice into
its threaded hole in jet holders. USE
LOW TORQUE.
REPLACE OLD VENTURI NUTS
with new venturi nuts, see Figure 6
(with a 20 mm socket or an
adjustable wrench). USE LOW
TORQUE.
4. CONVERTING VALVES
FOR PROPANE GAS
The bypass jet on each valve must be
adjusted. Your cooktop may come
with either hollow or solid valve
shafts. Determine the bypass screw
location accordingly. See figure 7.
a) Place all knobs to "Off" position.
b) Remove knobs.
c) Locate hole on cover which is
aligned to bypass screws. See Fig. 8.
d) Insert screwdriver in hole and turn
bypass screw clockwise until "botto-
med out". USE LOW TORQUE.
e) Replace knobs.
5. TEST TO ENSURE A SUCCESSFUL CONVERSION
Check for flame characteristics: flame should be blue with no yellow tip. See "Final Check" section of the Installation
manual.
High Altitude Installation:
This appliance is CSA certified for safe operation up to an altitude of 10,000 ft. without any modifications (except LP
conversion when applicable).
4
Figure 5
LP ORIFICES
91
91
4 Burner Models
91
117
74
5 Burner Models
Figure 7
Solid stem Hollow stem
By-Pass Jet
By-Pass Jet
Location Location
Questions?
1-800-735-4328
www.thermador.com
We look forward to hearing from you!
74
12.5T
12.5T
117
74
12.5T
91
9T
Solid stem
Figure 6
LP VENTURIS
9T
10.5
4 Burner Models
9T
10.5
12.5T
5 Burner Models
Figure 8
Hollow stem