Emergency Information; Putting Into Operation; Equipping The Torch - Abicor Binzel ABITIG GRIP 260 Instructivo De Servicio

TIG welding torch

3.2 Emergency information

4 Putting into operation

4.1 Equipping the torch

CAUTION
Describes a potentially harmful situation. If not avoided, it may result in slight
or minor injuries.
NOTICE
Describes the risk of impairing work results or the risk that may result in
material damage to the equipment.
In case of emergency, immediately interrupt the following supplies:
• Power, Gas
Further measures can be found in the "Power supply" operating instructions or
in the documentation of further peripheral devices.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
NOTICE
• The TIG welding torch may only be put into operation by authorized
personnel (in Germany see TRBS 1203).
CAUTION
Risk of injury
Puncture caused by sharpened electrode.
• Do not reach into the danger zone.
• Wear protective gloves.
4 Putting into operation
EN - 5