2) Insert the plug into a mains socket . The red
"Power" control lamp 4 lights up and the
appliance heats up . As soon as the green
"Ready" control lamp 2 lights up, the appli-
ance has heated up .
Open the lid using the handle 3 and place
the prepared burger patties onto the round
recesses on the lower griddle .
NOTE
►
The red "Power" control lamp 4 lights up as
soon as the mains plug is connected to a
mains socket .
Once the appliance has heated up, the green
"Ready" control lamp 2 also lights up .
However, the lamp may go out and switch
back on again at any time . This means that
the appliance is maintaining the temperature
and has heated up again a little .
►
Do not use the appliance to toast burger baps .
3) Now close the lid .
Fat and liquids will run into the fat drip tray 5
during use .
4) Check the food at regular intervals . At a
weight of 150 g, the burger patties need
around 10 minutes to cook all the way through
NOTE
►
The preparation time can vary depending
on the weight and composition of the burger
patties as well as your own personal prefe-
rences .
Once you are satisfied with the result, open
the lid using the handle 3 and remove the
burger patties from the griddle . To do this, use
only kitchen implements designed for coated
surfaces, e .g . a narrow spatula or other imple-
ments which are suitable for use on the coated
surfaces of kitchen appliances .
SBM 800 A1
ATTENTION! PROPERTY DAMAGE!
►
Do not use metallic, pointed or sharp implements
such as knives, forks, etc . If the non-stick coating
is damaged, stop using the appliance .
5) When you have finished cooking burgers, dis-
connect the plug from the mains power socket .
The red "Power" control lamp 4 goes out . This
is the only way to switch the appliance off .
Cleaning and care
DANGER – RISK OF ELECTRIC SHOCK!
►
Before cleaning the appliance, disconnect
the power plug from the mains power socket!
There is a risk of electric shock!
Never immerse the appliance in water or
any other liquid!
WARNING! RISK OF INJURY!
►
Always allow the appliance to cool down
before cleaning it . Otherwise there is a risk
of burns!
■
It is best to clean the device as soon as it has
cooled down . This makes food residues easier
to remove .
ATTENTION! PROPERTY DAMAGE!
►
Do not use abrasive or aggressive cleaning
materials . These can damage the surface of
the appliance!
►
Do not use metal implements such as knives,
forks, etc . If the non-stick coating is damaged,
stop using the appliance .
■
Empty the fat drip tray 5 . Then rinse it in warm
water containing a mild detergent . Then rinse the
fat drip tray 5 with clean water and dry it off .
GB │ MT
│
43
■