Black and Decker Stanley SLP 2050 Instrucciones De Montaje, Cuidado Y Uso página 15

CARE AND MAINTENANCE
Storage
• When your pressure washing session has been
completed, turn off the power switch. Unplug the
power cord from the outlet. Turn off the water
supply. Pull the trigger on the spray gun 2 - 3 times
to drain out the excess water and to release any
remaining water pressure. Do not allow the power
washer to run with no water flowing through it.
• Remove detergent tank and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
• Remove high pressure hose from spray gun and
unscrew the other end of the high pressure hose
from the power washer.
• Remove lance from the gun. Place the gun in
the holder on the side. Make sure to discard any
93919_16ANR024_Stanley 2-in1_ENG-FR-SP_11_17.indd 15
remaining detergent from the tank. Flush the
tank and nozzle head with fresh water to prevent
clogging.
• Hook the power cord around the L-shaped tab on the
top of the machine.
• The pressure hose is stored on the hose hook located
on the back of the handle.
•
DO NOT store the power washer where it is
exposed to freezing temperatures unless you
use an antifreeze designed for pumps.
recommended that you use this antifreeze (not
included) for storing in freezing temperatures.
Freezing will damage the pump unless this is added
to the power washer. If not using or if storing your
power washer for more than one month, it is also
recommended that an antifreeze is used to protect
the pump.
It is
15
16/12/23 下午1:06