Publicidad
Tools/Outils/Herramientas
3/4" Open-End Wrench
Clé à fourche de 3/4"
Llave de boca abierta de 3/4"
1.
Install the Bath Feet
Washer
Bath Lug
Rondelle
Oreille de baignoire
Arandela
Lengüeta de bañera
Nut
Écrou
Tuerca
Leveling Bolt
Bath Foot
Boulon de
Pied de baignoire
mise à niveau
Pie de bañera
Perno de
nivelación
Leveling Bolt Nut
Écrou de boulon de mise à niveau
Tuerca del perno de nivelación
WARNING: Risk of personal injury. Wear personal protective equipment and
obtain sufficient help to carefully lift or move the bath. Cast iron baths are
extremely heavy. Lift the bath properly to avoid personal injury.
If separate, loosely assemble the C-clamps to the bath feet using the washers and
nuts provided.
With help, carefully lift one side of the bath and wedge a stacked section of 2x4's
or equivalent under the bath.
Position feet on the two exposed bath lugs, and apply between 11 and 12.3 ft lbs
(14.9 and 16.7 Nm) to the C-clamp nuts.
1171029-2-A
Torque Wrench
Clé dynamométrique
Llave de torsión
6-3/16"
(15.7 cm)
Max/Max/Max
C-Clamp
Pince en C
3-13/16"
Prensa C
(9.7 cm)
Min/Min/Min
2-3/8" (6 cm) Adjustment
Réglage de 2-3/8" (6 cm)
Ajuste de 2-3/8" (6 cm)
2
Plus/Plus/Más:
• 2x4 Lumber
Montants de 2x4
Listones de 2x4
Torque the C-clamp nuts
between 11 and 12.3 ft lbs
(14.9 and 16.7 Nm).
Serrer les écrous des
brides en C entre 11 et
12,3 pi lb (14,9 et
16,7 Nm).
Aplique una torsión entre
11 y 12,3 lbs pie (14,9 y
16,7 Nm) a las tuercas de
las prensas C.
Kohler Co.
Publicidad
