Kohler K-T14664 Guía De Instalación Y Cuidado página 2

Tools/Outils/Herramientas
Silicone Sealant
Plumbers Putty
Joint en silicone
Mastic de plombier
Sellador de silicona
Masilla de plomería
3/8" Socket Driver W/ Extension
Tournevis à douille de 3/8" avec rallonge
Llave de dado de 3/8" con extensión
3/32"
Important Information
CAUTION: Risk of personal injury. If the water temperature is set too high,
scalding will occur. The water temperature should never be set above 120°F
(49°C).
NOTICE: Risk of product damage. Do not force the handle in any direction. Forcing
the handle will damage the valve.
NOTICE: Risk of product damage. Do not use long screws when installing the trim
to the K-306 valve for thin wall installations less than 1/2" (1.3 cm) thick. The long
screws may damage the valve. Consult the specification sheet for specific kits.
Observe all local plumbing and building codes.
The finished wall or bath/shower unit must be installed prior to installing the
trim.
NOTE: If you are not sure what type of valve you have when installing diverter
models, K-11748 model valves have a threaded diverter stem, K-305 model valves
have a smooth stem.
Diverter versions of this trim are designed for installation with K-11748 valve. If
the trim is being installed to a K-305 valve, a diverter button kit is required.
Consult the specification sheet for specific kits.
Shut off the main water supply.
Standard wall installations are typically tile, plaster, marble or similar materials.
Thin wall installations are typically fiberglass or acrylic.
For installations with a wall thicker than 3/4" (1.9 cm), a deep rough-in kit is
required. Consult the specification sheet for specific kits.
Informations importantes
ATTENTION: Risque de blessures corporelles. Si la température d'eau est trop
haute, des risques de brûlures peuvent avoir lieu. La température de l'eau ne
devrait jamais être supérieure à 120 °F (49 °C).
1139059-2-B
Sealant Tape
Rags
Ruban d'étanchéité
Chiffons
Cinta selladora
Trapos
Plus/Plus/Más:
• Emery Paper
Papier émori
Papel lija
• Copper tube or nipple
Tube ou mamelon en cuivre
Niple o tubo de cobre
• 90˚ 1/2" NPT Drop Elbow
Coude 1/2" NPT, 90˚
Codo de orejas de 90˚ 1/2" NPT
2 Kohler Co.