Antennas; Auxiliary Audio Equipment; Auxiliary Audio Devices; Remote Control - Magnat MC 2 S Notas Importantes Sobre La Instalación Y Certificado De Garantía

INStAllAtIoN

ANteNNAS

Connect the FM indoor antenna or a house antenna (provides better reception) to the rear
of the device (9), as well as the MW loop antenna (if required).

AuXIlIArY AuDIo eQuIpMeNt

Auxiliary audio devices are to be connected to the appropriate sockets before starting to
use the MC 2 S.

reMote CoNtrol

When using the remote control aim it at the infrared sensor on the MC 2 S (front panel/13).

FuNCtIoNS oF tHe MC 2 S

FuNCtIoNS oF tHe CD plAYer

playing a CD
• Open the CD compartment by pressing the EJECT button.
• Insert the CD into the compartment (with the label facing upwards).
• Close the compartment by pressing the EJECT button.
• Press PLAY to listen to the first track on the CD.
• The display shows the track number and the elapsed time of the current track.
pausing a CD
• Press the PAUSE button to pause the playback of the CD.
• Press the PLAY button to resume playback of the CD.
Selecting the track
• You can select the next or previous track during playback by pressing the SKIP buttons
on the MC2 unit (5, 6) or on the remote control (17).
• A track can also be selected directly by using the numeric buttons on the remote control
(10) to enter the track number.
Sensor
~ 30°
~ 30°
GB
FuNCtIoNS oF tHe MC 2 S
Searching within a track
• Press the right/left search button on the remote control (16) to search forwards/backwards
within a track respectively. Pressing the PLAY button will stop the search function.
Stopping playback from a CD
Press the STOP button.
CD repeat mode
Repeating a track:
Start the CD. The REPEAT button repeats the current track. The following appears in the
display: REP TRACK.
Repeating the entire CD:
Start the CD.
Press the REPEANT button twice.
The following appears in the display: REP ALL.
Stopping the repeat function:
Keep pressing the REPEAT button until REP OFF appears in the display.

FuNCtIoNS oF tHe tuNer

Selecting the tuner band
• Select TUNER as the audio source using the SOURCE (MC 2 S, pos. 7) or TUNER button
(on the remote control, pos. 4).
• Select the FM or AM band using the FM/AM button (remote control, pos. 7).
• Press the FM-MODE button (remote control (8)) to switch between mono reception
(recommended for poor reception) or stereo reception.
Station search
• Select TUNER as the audio source and choose the band (see above).
• Use the TUNE buttons on the front of the MC 2 S (5, 6) or the TUNING buttons on the
remote control (16):
• Briefly pressing these buttons increases or decreases the tuning frequency by 50 kHz.
• Pressing and holding these buttons searches for the next or previous station on the
band.
16