Remote Control; Installation; Speakers; Antennas - Magnat MC 20 Notas Importantes Sobre La Instalación / Certificado De Garantía

operAtIoNAl eleMeNtS AND CoNNeCtIoNS - reAr / CoNNeCtIoNS
1 poWer SWItCH
Switches the device on and sets it in the
standby mode. If the switch is set to the
"OFF" position, the device is disconnected
from the mains supply.
2 MAINS CoNNeCtIoN
For connecting the supplied mains cable.
3 FuSe
Only use a fuse with the parameters
indicated on the rear of the device.
4 SpeAKer terMINAlS
For the connection of stereo speakers
with an impedance rating of 4-8 ohms (the
correct polarity must be taken into
account).
5 Sub output
Output for connecting an active
subwoofer.
6 reC output
Fixed level output e.g. for the connection
of a tape recorder.
7/8 AuX INputS
Additional audio sources can
connected here.
9 FM ANteNNA CoNNeCtIoN
For connecting the supplied FM indoor
antenna or a house antenna.
10 AM ANteNNA CoNNeCtIoN
For connecting the supplied AM loop
antenna.
GB

INStAllAtIoN

Place the device on a firm, even surface while paying attention to the minimum distances.

SpeAKerS

The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows:
Only use high-quality audio speaker cables with a conductor cross section of min.
1.5 - 2.5 mm². Strip approx. 10 mm from the cables and twist the ends. Loosen the terminal
screws one after the other and insert the stripped ends into the holes. Re-tighten the
be
terminal screws. Make sure you pay attention to the correct polarity.
You can also use prefabricated cables with 4mm banana plugs or forked fittings.

ANteNNAS

Connect the FM indoor antenna or a house antenna (provides better reception) to the rear
of the device (9), as well as the MW loop antenna (if required).
AuXIlIArY AuDIo eQuIpMeNt
Auxiliary audio devices are to be connected to the appropriate sockets before starting to
use the MC 20.

reMote CoNtrol

When using the remote control aim it at the infrared sensor on the MC 20 (front panel/13).
15
Sensor
~ 30°
~ 30°