Concept VR3000 Manual Del Usuario página 95

Instructions for pairing the device
1. At the beginning of pairing, you need to be connected to your Wi-Fi network.
2. Scan the QR code below or on the bottom of the vacuum robot (Figs. 6–7).
3. Select your Wi-Fi network to which the robot needs to connect to and enter your password. (Fig. 8)
4. Restart the vacuum robot using the power switch on its side.
5. Press the top button for 3–5 seconds (Fig. 9). A sound signal can be heard and the Wi-Fi icon on the robot
starts to flash.
6. Confirm by pressing „Confirmed above" and continue.
Fig. 5
7. Your phone will automatically try to connect to the robot and it will connect it to your Wi-Fi network. (Fig. 10)
8. Successful pairing (Fig. 11)
Fig. 10
PAIRING TROUBLESHOOTING
• Verify that your Wi-Fi network password is correct.
• After restarting the robot (Fig. 9), wait at least 1 minute before giving further instructions.
• The device only supports 2.4 GHz Wi-Fi networks.
• The router is overloaded as many other devices are connected.
• When attempting to connect to the robot (Fig. 10), try to manually connect to its Wi-Fi network „ROBOT ###".
VR3000
Fig. 6 Fig. 7
Fig. 11 Fig. 12
Fig. 8 Fig. 9
EN
95