essentiel b EVT 302c Manual De Utilización página 15

assembly
WARNING: Completely assemble the fan before
turning it on.
Fitting the foot on the base
Unscrew the pre-fitted retaining screw from the base (17).
1.
Insert the foot (14) into the hole in the centre of the base (16) and screw it in.
2.
Insert the retaining screw (17) under the foot and screw it to the foot.
3.
Unscrew the pre-fitted nut on the motor unit (18). Insert the motor unit (13) into the foot
4.
(14) and tighten the screw (18) to secure the motor unit to the foot.
Assembling the guards and blades
Using a screwdriver, unscrew the 4 pre-fitted screws (7) around the shaft (10) of the
5.
motor unit (13) and set them aside.
Position the rear guard (8) on the motor unit (13). The handle (9) should be towards the
6.
top. Attach the rear guard (8) to the motor unit (13) using the 4 screws (7).
Unscrew the screw (6) on the blades (5).
7.
Place the blades (5) on the motor shaft (10) and tighten the retaining screw (6) on the
8.
blades (5) at the flat spot (notch on the motor shaft). Make sure that the blades (5) can
rotate freely.
Unscrew the retaining screw (1) and nut for the guards (2), pre-fitted on one of the guards.
9.
Place the front guard (3) on the rear guard (8), by lining up the holes for the retaining
10.
screw (1) and nut for the guards (2). Secure the guards using the 5 clips (4). Insert the
screw (1) into the hole provided for this purpose on the guards, and then screw on the
nut (2). Make sure that the 2 guards are securely attached to each other.
use
Plug the power cord into a wall socket.
1.
Set the speed selector (12) to the desired position:
2.
0: off
1: low speed
2: medium speed
3: high speed
To start or stop oscillation, press or pull on the oscillation pin (11).
3.
15
V.3.0
assembly